Colourland Big Tree High Gloss (Wood & Metal) 2000 5L

NOTE: The colours shown here are as close to actual paint colours as modern printing techniques allows. Due to different computer monitors/calibrations colours may vary slightly from the picture. *Colourland Big Tree High Gloss is a general purpose solvent based enamel gloss paint. *Suitable for use on all types of wood and metal surfaces. *For decoration and protection of all types of interior and exterior wood and metal surfaces. *Fast Drying *High Gloss Retention *Excellent Coverage *Non Yellowing COMPOSITION: Pigment: Lightfast Non - Lead Pigments. Binder: Modified Hydrocarbon Resin. Volume Solids: White 54% (Nominal), other colours will vary. Thinner / Cleaner: White Spirit. PROPERTIES: Texture: High Gloss Smooth Finish. Colour: A wide range of colours. Please refer Colourland High Gloss # 2000 Colour Card. Theoretical Coverage: 15 – 17 m2/Litre. Drying Time: Touch Dry 1 hours. Hard Dry 4 hours. Recoating Interval: 3 – 4 hours. APPLICATION METHOD: Brush: For normal use thinning is not usually necessary. If required add up to 10% by volume with Colourland 1000 thinner. Roller: For normal use thinning is not usually necessary. If required add up to 10% by volume with Colourland 1000 thinner. Conventional Air Spray: Thin with 10% - 20 % by volume with Colourland 1000 thinner and adjust to requirement. Airless Spray: Ready for use. Thinning is not usually necessary SURFACE PREPARATION: Wood :Wood must be dry and free from grease, dirt and other contaminants, smoothen surface with suitable grade sand paper and dust off before application of undercoat and paints. Metal: Surface must be dry and free from grease, dirt and other contaminants. Steel surfaces should be sanded or wire-brushed to remove mill scales and rust. For best result steel surfaces should be prepared by hand or power tool to BS 7079 Part 1: 1989 S T 3 standard. Galvanised and Aluminium surfaces should be cleaned and degreased, apply an appropriate Etch Primer to ensure good adhesion. Previously Painted: Remove all loose, defective and unstable paint film. Rusted and defective areas should be sanded and feather edged and spot primed with Colourland Zinc Chromate Primer before applying subsequent coatings.